U-Line BI-2115 Guia de Instalação

www.U-LineService.comPhone (414) 354-0300 • FAX (414) 354-7905Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696OnlineService@U-

BI-2115 — Ice Makerwww.U-LineService.com 10 08/2006 3. Attach the door panel to the overlay panel using #10 x 5/8" wood screws and nylon spacers.

BI-2115 — Ice Maker08/2006 11 www.U-LineService.com4. Attach Top Pivot Plate to door handle, on side where hinges will be. Use the two #8-32 x 1/2&quo

BI-2115 — Ice Makerwww.U-LineService.com 12 08/2006Checking Door AlignmentThe unit’s door is aligned at the factory before shipment. However, its alig

BI-2115 — Ice Maker08/2006 13 www.U-LineService.comCAUTIONPlumbing installation must observe all state and local codes. All water connections MUST BE

BI-2115 — Ice Makerwww.U-LineService.com 14 08/2006Electrical SpecificationsCAUTIONElectrical installation must observe all state and local codes. Thi

BI-2115 — Ice Maker08/2006 15 www.U-LineService.comInstallation of the BI21151. Open the water supply valve in the main water source.2. Make sure the

BI-2115 — Ice Makerwww.U-LineService.com 16 08/2006Start-Up TroubleshootingProblemQ:Unit does not appear to turn on when switch is set to ON.SolutionA

©2006 U-Line CorporationPublication No. 30145E08/2006 Rev. BU-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-i

BI-2115 — Ice Makerwww.U-LineService.com 2 08/2006ContentsExterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4Cut-Out Dime

BI-2115 — Ice Maker08/2006 3 www.U-LineService.comGeneral PrecautionsUse this appliance for its intended purpose only and follow these general precaut

BI-2115 — Ice Makerwww.U-LineService.com 4 08/2006After all the protective coating has been removed from the unit/door, clean all Stainless Steel surf

BI-2115 — Ice Maker08/2006 5 www.U-LineService.comProduct DimensionsPlease note that the unit has adjustable feet that can add one additional inch to

BI-2115 — Ice Makerwww.U-LineService.com 6 08/20064. Remove the two door closer inserts from the existing bottom hinge and install as shown on the new

BI-2115 — Ice Maker08/2006 7 www.U-LineService.comSide-By-Side Installation InstructionsFor a complete refreshment center, install your BI2115 Ice Mak

BI-2115 — Ice Makerwww.U-LineService.com 8 08/20062. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, mov

BI-2115 — Ice Maker08/2006 9 www.U-LineService.com2. Create a relief (Figure 15) for pivot plate by cutting notch in top corner of overlay panel. Refe