U-Line 29 Series Guia de Instalação Página 12
- Página / 19
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
U-Line Door Panel Installationl 10
9 Door Panel Installation
Custom 1/4'' Thick Door Panel Insert
Door Panel Preparation
A custom door panel may be inserted into the doorframe. Custom
door panels can be flat or raised, as long as the maximum panel
thickness, where inserted into the door reveal (channel), is no
more than 1/4" thick. For raised panels, the depth of the reveal is
1/4" on all four sides.
IMPORTANTIMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
Panel Dimensions.
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
1. Remove top hinge screw pin with
Phillips head screwdriver. Remove
door by tilting forward and lifting off
bottom hinge pin.
2. Pull door gasket out of groove (top
edge of door only). Start in the middle
and pull outward, moving toward the
edge . This may take some force.
Model Width Height
CLRCO2175 23 1/32” 27 11/16”
CLR2160 14 1/32” 27 11/16”
CO1175 22 15/16” 26 15/16”
CO29 19 13/16” 21 13/32”
CO2175 23 1/32” 27 11/16”
3. Remove the two outside screws holding
door handle. Slightly separate door
handle from door.
4. Pull handle up and off.
5. Slide custom door panel insert into 1/4-
inch channel in door front.
IMPORTANTIMPORTANT
Use care not to damage magnet, located on door bottom,
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
6. Holding door gasket out of the way, replace handle on door,
making sure it is seated properly on insert and that screw holes
line up.
7. Install two small screws removed in
Step 3
.
8. Starting at the corners and working inward, push door gasket
into place on door.
9. Place door on bottom hinge pin and install upper hinge screw.
- INSTALL GUIDE 1
- 1 Table of Contents 2
- Safety Alert Definitions 3
- General Precautions 3
- Product Registration 4
- Product Description 4
- Tools / Material Required 4
- Exterior Cleaning 4
- Cut-Out Dimensions 5
- All Models 6
- Other Site Requirements 7
- Door Alignment and Adjustment 8
- Door Reversability 8
- Reversing the door 8
- 1/8" 10
- (3.175 mm) 10
- 9 Door Panel Installation 12
- Electrical Specifications 13
- Receptacle Location 13
- Water Supply Connection 14
- Factory-Installed Drain Pump 15
- Final Water Connection: 16
- Turn Foot to Adjust 17
- Installation Troubleshooting 18
- INSTALLATION GUIDE 19
- ©2009 U-Line Corporation 19
Manuais e produtos relacionados com Frigoríficos U-Line 29 Series
Frigoríficos U-Line 2115WC Guia de Instalação
(20 páginas)
(20 páginas)
Frigoríficos U-Line CO2175 Guia de Instalação
(22 páginas)
(22 páginas)
Frigoríficos U-Line 2275DWRR Manual de Serviço
(180 páginas)
(180 páginas)
Frigoríficos U-Line 15WC Guia de Instalação
(12 páginas)
(12 páginas)
Frigoríficos U-Line 2075DWRWC Manual de Serviço
(76 páginas)
(76 páginas)
Frigoríficos U-Line BI98 Manual do Utilizador
(33 páginas)
(33 páginas)
Frigoríficos U-Line 75WC Guia de Instalação
(13 páginas)
(13 páginas)
Frigoríficos U-Line CO2175F Manual do Utilizador
(2 páginas)
(2 páginas)
Frigoríficos U-Line 29R Guia de Instalação
(14 páginas)
(14 páginas)
Frigoríficos U-Line 1115R Guia de Instalação
(16 páginas)
(16 páginas)
Frigoríficos U-Line UCLR2160W00 Guia de Instalação
(24 páginas)
(24 páginas)
Frigoríficos U-Line 2175BEVOL2 Manual do Utilizador
(17 páginas)
(17 páginas)
Frigoríficos U-Line C029 Manual do Utilizador
(2 páginas)
(2 páginas)
Frigoríficos U-Line UBI95B00A Guia de Instalação
(19 páginas)
(19 páginas)
Powermatic Single End Dovetailer DT45 manuali
Manuali dei proprietari e guide per l'utente per Attrezzi Powermatic Single End Dovetailer DT45.
We fornisce 1 manuali pdf Powermatic Single End Dovetailer DT45 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Comentários a estes Manuais