U-Line 2075DWRWC Manual do Utilizador descarregar pdf (Página 11)

CONNECTING THE WATER SUPPLY

Install a 1/4 inch outside diameter copper water line (not

supplied with unit) from the nearest COLD water pipe. When

connecting the water supply, follow these guidelines:

• Review the local plumbing codes before you install the unit.

• In most instances, the cold water supply will come from the base-

ment through a hole in the floor.

• The water pressure should be between 15 and 150 psi.

• Install a shut-off valve in the 1/4 inch outside diameter supply line

(not supplied with unit).

• Connect sufficient tubing to the unit to allow the unit to be moved

for cleaning and servicing. However, make certain that the tubing

is not pinched or damaged during installation.

• U-Line recommends the use of copper tubing for installation.

1. Locate the compression fitting

and ferrule packed in the unit.

Slide the compression fitting

and ferrule over the 1/4 inch

outside diameter water supply

line. Do not use thread seal-

ing compound or tape. Using

two wrenches, tighten the

compression fitting on the

supply line (see Figure 7). Do

not overtighten.

Figure 7

UL134_CO

2. Carefully bend the water supply

line into position and connect

the line to the solenoid valve

(see Figure 8). Avoid kinking

the water supply line.

Figure 8

UL103_CO

WATER

CONNECTION

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sem comentários

U-Line 2075DWRWC Manual do Utilizador Página 11