U-Line 3018CLR SERIES Guia de Instalação descarregar pdf (Página 10)

8 u-line.com

NOTICE

Make certain the display cable remains securely seated in

the inner door channel, see below.

5. The frame should be aligned with the outside edge (opposite the

hinge) and high enough to align with the highest point in the door.

NOTICE

Due to differences in floor construction or surrounding

cabinetry, the frame may not sit flush with the top of the

door.

6. Secure overlay to door

using clamps. A robust

tape may also be used.

U-Line recommends the

use of bar clamps to

securely clamp the

overlay to the door. If

using tape be certain the

tape will not damage

overlay finish upon

removal.

7. Using a 7/64" drill bit,

drill 6 pilot holes into

the wood panel

1/2" (13 mm) deep using

the holes in the door

frame as a guide.

8. Locate 6 of the #6x

1-1/2" screws provided

with your unit.

9. Using a Phillips

screwdriver, place one

screw into each of the 6

pilot holes and screw

down. Do not

overtighten screws.

10. Be sure the screws force

their way past the opening on the gasket channel and sit flush

against the bottom of the channel.

11. Remove clamps from door.

NOTICE

If frame requires additional adjustment after removing

clamps, slightly loosen each screw and adjust frame as

necessary. Tighten screws upon completion.

12. Starting at the corners, re-install the gasket into the gasket channel

in the frame. Make sure the gasket is fully seated. This may take

some force.

Display

Cable

Inner Door

Channel

Align Frame

Against

Door Edge

First

Align Top Of Panel With Highest Point Of Door

Door

Frame

Wood

Panel / Frame

Door

Bar

Clamp

Bar

Clamp

Overlay Panel Overlay Panel

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários

U-Line 3018CLR SERIES Guia de Instalação Página 10

Comentários a estes Manuais

Manuais e produtos relacionados com não U-Line 3018CLR SERIES