U-Line 3018CLR SERIES Guia de Instalação descarregar pdf (Página 15)

u-line.com 13

8. Locate the U-Line supplied hose fitting. Ensure the end on the

copper tubing has been cut straight and is free of burrs. Slide the

compression nut and ferrule onto the copper tubing as shown

below.

9. Feed the complete assembly into the garden fitting and tighten.

Attach to the water valve located in the front of the unit.

10. Gray hooks are located in the front of the condenser and behind

the condenser. Use these to secure the copper tubing to be within

two inches of the top of the unit.

11. Turn on water and check for leaks.

12. Re-attach back panel and front panel.

U-Line Water Hookup Kit Connection

CAUTION

Turn off water supply and disconnect electrical supply to

unit prior to attempting installation.

1. Turn off water supply and disconnect electrical supply to unit

prior to attempting installation.

2. Remove back panel of unit.

3. Remove front panel of unit. See image below for location of front

panel screws.

4. Take one end of the braided line and feed it through the front of

the unit between the condenser and the right side of the unit. This

tubing should be within two inches of the top of the compartment.

5. Take the end of the braided line and put the line through the hole

in the back panel.

6. Locate the desired cold water supply location.

7. Attach the end of the braided line to this cold water supply

location. Leave approximately 4' of water line to be coiled behind

the appliance.

8. Attach the garden hose connection from the kit to the front of the

unit.

9. Attach the front of the braided line to this garden hose connection.

Ensure that there is still approximately 4' of water line is coiled

behind the appliance. The water line should be looped in 2 coils.

This will allow the line to flex when removing the unit for cleaning

and servicing. Do not kink or pinch the coiled line.

10. Turn on water supply and check for leaks.

11. Re-attach back panel and front panel.

9/16" Wrench

1/4" Copper Water

Supply Line

7/16" Wrench

From Water Supply

to Ice Maker

Compression Nut

Ferrule

Front Panel

Remove screws

(one on each side)

to access behind

the front panel

Water inlet line

should be within 2

inches of the top of

the compartment

1 2 ... 10 11 12 13 14 15 16 17 18

Comentários a estes Manuais

Sem comentários

U-Line 3018CLR SERIES Guia de Instalação Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com não U-Line 3018CLR SERIES